|
ixtab, you rock. I just read the entire thread but my issue hasn't come up yet. I have a K3 that is unresponsive. The screen is stuck on an advertisement and has been for weeks. I have let the thing charge for a week and no response. I've removed the battery and it's at 3.7V which should be perfect. When I plug into the computer, sometimes it doesn't show up in device manager at all, other times it comes up as "SE blank RINGO". No amount of holding the powerswitch seems to make a difference.
I downloaded Kubrick 2.1 and put it on a USB stick. I boot into Kubrick just fine on multiple computers. I follow the instructions and the USB downloader mode check passes. At the Flashing Kernel prompt after a second or two, the status goes to "Device Ready". Does this mean the Kernel was flashed or that the Kernel is ready to be flashed? After leaving it at the screen for a few minutes, the Flashing Kernel status stays at "device ready" so I just hit next.
At the Flashing Main partition, the status says "Flashing Main partition 0%" and then immediately says "Flashing done". Obviously it isn't done because it is supposed to take hours. Any idea about what my problem is?
|