Quote:
Originally Posted by timewyrm
After logging out of my kobo account, I tried to do a setup, but it said "device already configured". Is there a step missing ?
|
The pinhole reset just flushes the device... Doing a factory reset from the settings menu will format the device and restore it to a clean install. Make sure the device is off and the memory card removed before you do this. You want to make sure the device is a clean install... connect to the desktop follow the setup instructions. wait till the firmware downloads and installs. Once the firmware installs you can insert the memory card the glow will reread the books on the memory card and add them to the data base. Then you can connect again to the computer and use calibre to set up the shelves. Also make sure you eject the reader when you need to disconnect from the pc as failure to do so can result in corruption of the device...
Jack