[mconh]

I have updated (side loaded) two touches and one Glo from 2.1.5 to 2.4. Another new Glo was side loaded from factory firmware to 2.4. then synced. All books are on MSD cards.
I have the same two problem on all four units.

1. On starting all readers boot to the home screen message "your library is empty add a book" and stays there. Tapping Reading (even though it is on reading) brings up the home screen and the five covers which take some time to load. I get the double flash on the home screen on boot which used to load the reading covers on 2.1.5.

2. All covers on all four units now have white bars down the sides. I never get the high definition full screen covers now. Also, even though the images folder has all the required images the Library images all load slowly, one at a time all the time.

This seems to be a retrograde on the covers compared to 2.1.5, which I may revert to yet again.

Any ideas or suggestions would be appreciated.