MobileRead Forums - View Single Post

phossler · 02-12-2013, 11:31 PM

9.18 and Sigil (6.2 and 6.902beta) have both started misbehaving (Vista 32 bit PC)

Both were working fine, and then Sigil would start and the exit immediately

Calbre was a little better; I can open it now, but 'Bulk Convert' opens a dialog, but just clicking on Convert causes an immediate exit. Same for Edit Metadata.

Restarted PC, uninstalled / reinstalled both several time in different orders.

No difference.

Figured out how to start Calibre in debug mode, the the last entry in the log file is for opening a book. Crashs without adding anything when I go to edit metadata.

Exported and deleted TrollTech from registry, and Calibre recreates keys as expected.

I has MS 2010 C++ redistributable 10.0.40219 but unisntalled to to let Calibre install a slightly older version but no difference

The only thing 'funny' was when I was installing 9.18 there was a message I'd never seen before about files / serices in use and to restart PC afterwards. Never had that before.

Everything else on the PC is working fine

ANY ideas or suggestions .... please

Paul

02-12-2013, 11:31 PM	#1
phossler Wizard Posts: 1,087 Karma: 447222 Join Date: Jan 2009 Location: Valley Forge, PA, USA Device: Kindle Paperwhite	9.18 (and Sigil) fail to start 9.18 and Sigil (6.2 and 6.902beta) have both started misbehaving (Vista 32 bit PC) Both were working fine, and then Sigil would start and the exit immediately Calbre was a little better; I can open it now, but 'Bulk Convert' opens a dialog, but just clicking on Convert causes an immediate exit. Same for Edit Metadata. Restarted PC, uninstalled / reinstalled both several time in different orders. No difference. Figured out how to start Calibre in debug mode, the the last entry in the log file is for opening a book. Crashs without adding anything when I go to edit metadata. Exported and deleted TrollTech from registry, and Calibre recreates keys as expected. I has MS 2010 C++ redistributable 10.0.40219 but unisntalled to to let Calibre install a slightly older version but no difference The only thing 'funny' was when I was installing 9.18 there was a message I'd never seen before about files / serices in use and to restart PC afterwards. Never had that before. Everything else on the PC is working fine ANY ideas or suggestions .... please Paul Last edited by phossler; 02-12-2013 at 11:33 PM.