Quote:
Originally Posted by knc1
That is the one which I use, and that I recommend.
But anything will do - if it is 1.8 volt serial
Just be sure anything you find can be set to that level (most you find are either 3.3 or 5.0 volt).
|
Hi
Today i got a cable that you advised - TTL-232RGVREG1V8-WE
i connect it to Kindle board as following:
- TXD wire of the cable (ORANGE) to TXD foot on the board
- RXD wire of the cable (Yellow) to RXD foot on the board
- GND (Black) to GND
when cable is connected to PC its detects as COM4
in PuTTy i try to connect to device to via COM4,speed 9600,data bits 8,stop bits 1,parity none and flow control - none
as a result the window is opened but i dont see anything
i cannot write in terminal window
may be i miss something?
any advise
thanks