I regularly receive the following error when connecting my PRS-500. It doesn't seem to interfere with the use of the device, but anyhow:
Quote:
Error communicating with device
Error: Could not read 4096 bytes on the bulk bus. Error code: -110
Failed to perform job: Job #7
Further device related error messages will not be shown while this message is visible.
Detailed traceback:
Traceback (most recent call last):
File "library.pyz/calibre.gui2.jobs", line 64, in run
File "library.pyz/calibre.gui2.device", line 76, in books
File "library.pyz/calibre.devices.prs500.driver", line 158, in run_session
File "library.pyz/calibre.devices.prs500.driver", line 799, in books
File "library.pyz/calibre.devices.prs500.driver", line 158, in run_session
File "library.pyz/calibre.devices.prs500.driver", line 479, in get_file
File "library.pyz/calibre.devices.prs500.driver", line 396, in _bulk_read
File "library.pyz/calibre.devices.prs500.driver", line 383, in bulk_read_packet
File "library.pyz/calibre.devices.libusb", line 248, in bulk_read
Error: Could not read 4096 bytes on the bulk bus. Error code: -110
|