MobileRead Forums - View Single Post

steen · 08-05-2008, 08:32 PM

I've successfully updated my eBook Library software to 2.2 and my PRS-505 firmware to 1.1. However, when I plug my Reader into the USB port, an item comes up in the Status menu: "Sync Reader" and the status is listed as: "Completed - transferred 0 of 1 files" and keeps my Reader in the "Do not disconnect" mode. If I close out the Library, it goes back to "USB connected" but usually requires a soft reset to pull it out of the refresh mode.

Any ideas? I tried searching around but couldn't see anything like this.

Thank you!

08-05-2008, 08:32 PM	#1
steen Member Posts: 16 Karma: 10 Join Date: Aug 2008 Location: Orlando, FL Device: Sony Reader PRS-505	"Sync Reader" error I've successfully updated my eBook Library software to 2.2 and my PRS-505 firmware to 1.1. However, when I plug my Reader into the USB port, an item comes up in the Status menu: "Sync Reader" and the status is listed as: "Completed - transferred 0 of 1 files" and keeps my Reader in the "Do not disconnect" mode. If I close out the Library, it goes back to "USB connected" but usually requires a soft reset to pull it out of the refresh mode. Any ideas? I tried searching around but couldn't see anything like this. Thank you!