Quote:
|
However, to get the official updater to work, you'll need to either unzip & edit a file inside the official flasher (see the post here) to persuade it that the firmware versions are different, or set it into update mode via the Universal Flasher.
|
I used Update mode from the Universal Flasher but I may have removed the SD card too soon. Now the unit starts up and gives me the message:
"Firmware update did not complete successfully. Please try again."
Tried "pin reset", switching off and on but it keeps coming up with this error regardless of whether the SD card is in or not.
When I connect it to my PC the message changes to:
"Updating firmware now" (unit shows as drive on PB with name "Protected!!") and nothing else happens.
One small step for an intelligent person, one step too far for David!
HELP!