Quote:
Originally Posted by knc1
Enter: dmesg
After plugging in the adapter cable.
The messages will tell you which /dev/ttyUSB# devices where assigned.
It may tell you that more than one was assigned.
Select in your copy of minicom each of the devices listed, one of them will work (the other is a control channel to the converter chip)
|
After entering "dmesg", I find that the pl2303 converter is listed as ttyUSB0.
However, I still don't see any output in minicom. Perhaps the issue is with the DXG; once I have minicom open and monitoring, what should I do with the DXG? Reboot? Go to recovery mode?