# Tools required: Small Phillips Screw Driver, Small Flathead, exacto razor & Safe Open Tool (or w/e you have)
Gather all necessary tools and place your Kindle DX on a clean flat surface, use a soft cloth or towel to place under it.
Step 1
To get started, flip the unit over so we can remove the top grey plastic bezel.
There are 2 screws to remove in this step after the grey bezel comes off. see sub picture for screw removal location. the other one is on the opposite side. These arent hidden so they are pretty easy to get to.
After the 2 screws are removed, slide the back panel down towards the bottom of the unit. this will free the entire back panel.
Step 2
Now remove 22 more screws located on the back panel. Visibly shown here, not too much to do in this step, start unscrewing!
After all the screws have been removed, unplug the two speaker molex connections located left and right of the battery.
Now remove the white/black? bezel to reveal the Kindle DX System Board.
Step 3
Remove the 3 clips circled (SEE THE PICTURES IN THE LINK BELOW). There are also 2 screws remaining for the wireless card. A plastic bezel protects the wireless module screws, remove this by popping the clips.
Wireless card shown: (E727NV WN2)
Rip it out, put back together.
(you can get this info from
http://www.rapidrepair.com/Merchant2...n=cp-kindle-dx) - the pictures are here too to go with this...
Not too many steps
doesn't look too tough. good luck.