MobileRead Forums - View Single Post

knc1 · 08-29-2012, 10:13 AM

I have been hoping to find a good reason to NOT rebuild the Freescale RAM kernel.
Not having much luck with reaching that goal.

New K3 problem in another thread here:
How well does this binary work under "low clock speed, low voltage, low power" mode of operation (set by the SoC hardware, outside of the control of the current RAM kernel)?

@Hawhill ::
I wrote earlier I wasn't going to change the protocol.
But it is looking more and more like we need an enhanced "get status or get info" command so that the host software can tell if it is safe to proceed.

Speed bump: The i.MX35 "manual" is over 3,000 pages long. It will take awhile to read it.

08-29-2012, 10:13 AM	#133
knc1 Going Viral Posts: 17,212 Karma: 18210809 Join Date: Feb 2012 Location: Central Texas Device: No K1, PW2, KV, KOA	I have been hoping to find a good reason to NOT rebuild the Freescale RAM kernel. Not having much luck with reaching that goal. New K3 problem in another thread here: How well does this binary work under "low clock speed, low voltage, low power" mode of operation (set by the SoC hardware, outside of the control of the current RAM kernel)? @Hawhill :: I wrote earlier I wasn't going to change the protocol. But it is looking more and more like we need an enhanced "get status or get info" command so that the host software can tell if it is safe to proceed. Speed bump: The i.MX35 "manual" is over 3,000 pages long. It will take awhile to read it. Last edited by knc1; 08-29-2012 at 10:18 AM.