Thread: Help Unbricking K3 with ATK
View Single Post
Old 08-27-2012, 05:01 AM   #1
tootie1221
Junior Member
tootie1221 could sell banana peel slippers to a Deveel.tootie1221 could sell banana peel slippers to a Deveel.tootie1221 could sell banana peel slippers to a Deveel.tootie1221 could sell banana peel slippers to a Deveel.tootie1221 could sell banana peel slippers to a Deveel.tootie1221 could sell banana peel slippers to a Deveel.tootie1221 could sell banana peel slippers to a Deveel.tootie1221 could sell banana peel slippers to a Deveel.tootie1221 could sell banana peel slippers to a Deveel.tootie1221 could sell banana peel slippers to a Deveel.tootie1221 could sell banana peel slippers to a Deveel.
 
Posts: 8
Karma: 3200
Join Date: Aug 2012
Location: UK
Device: Kindle keyboard
Help Unbricking K3 with ATK
I downloaded the image kernel 3.0.2 and using ATK 1.7 to try to install new image on my kindle keyboard b008 using the guide K3noobdebrickatk
The kindle is in usb mode and shows up in devices as
-jungo
-MX35
-WinDriver
I am using the drivers that came with ATK 1.7
But when I run ATK enter the settings in the guide K3noobdebrickatk I get an error message
"Failed to intial flash or Do not support this Flash , please reset the target"
any help please so I can unbrick this kindle
Last edited by tootie1221; 08-27-2012 at 06:58 AM.
tootie1221 is offline   Reply With Quote