MobileRead Forums - View Single Post - Noob's guide to debricking through ATK :D

Pixelpille · 08-24-2012, 01:06 PM

Went back to my K3 with the ATK: still throws "Failed to initial flash or Do not support this Flash, please reset the target" at me.

Also tried to use the k3flasher, which also doesn't seem to work for me

Code:

pixelpille@ubuntu:/mnt/HDD/k3flasher$ sudo ./k3flasher mx35to2_mmc.bin program 0x00041000 kernel.bin 
I: found suitable device
E: wrong transfer length, wanted to receive 8 bytes but received 4 bytes.
I: above error can be ignored, it's due to the device being in ROM kernel mode
I: RAM kernel should be running now. Trying to re-open device: .
I: got it.

and then after a while (few seconds)

Code:

E: reading data from device: LIBUSB_ERROR_NO_DEVICE
E: aborting. It is suggested you power-cycle the device.

Are they supposed to say anything like "wohoo, something happened" ?
Any other hints?

08-24-2012, 01:06 PM	#109
Pixelpille Junior Member Posts: 6 Karma: 10 Join Date: Aug 2012 Location: Neubrandenburg Device: Kindle 3	Went back to my K3 with the ATK: still throws "Failed to initial flash or Do not support this Flash, please reset the target" at me. Also tried to use the k3flasher, which also doesn't seem to work for me Code: pixelpille@ubuntu:/mnt/HDD/k3flasher$ sudo ./k3flasher mx35to2_mmc.bin program 0x00041000 kernel.bin I: found suitable device E: wrong transfer length, wanted to receive 8 bytes but received 4 bytes. I: above error can be ignored, it's due to the device being in ROM kernel mode I: RAM kernel should be running now. Trying to re-open device: . I: got it. and then after a while (few seconds) Code: E: reading data from device: LIBUSB_ERROR_NO_DEVICE E: aborting. It is suggested you power-cycle the device. Are they supposed to say anything like "wohoo, something happened" ? Any other hints?