Thread: Firmware updates for the M90
View Single Post
Old 05-25-2012, 10:54 AM   #48
davidjoseph1
Connoisseur
davidjoseph1 can tell if an avocado is ripe without touching it.davidjoseph1 can tell if an avocado is ripe without touching it.davidjoseph1 can tell if an avocado is ripe without touching it.davidjoseph1 can tell if an avocado is ripe without touching it.davidjoseph1 can tell if an avocado is ripe without touching it.davidjoseph1 can tell if an avocado is ripe without touching it.davidjoseph1 can tell if an avocado is ripe without touching it.davidjoseph1 can tell if an avocado is ripe without touching it.davidjoseph1 can tell if an avocado is ripe without touching it.davidjoseph1 can tell if an avocado is ripe without touching it.davidjoseph1 can tell if an avocado is ripe without touching it.
 
Posts: 56
Karma: 130472
Join Date: May 2011
Device: BooxM90,M92*3,M96,N96, I86ml,C67ml,Kepler, Poke2,Nova3,MaxLumi2,TabUPC
That was it! Thanks, Booxtor! (Although several months ago, I was reading the Onyx INternational discussion board, and failures of the capacitive buttons seemed to be common in the M90.) I confess I have been babying my device. I was freaked out by the reports of unreliability of the M90, and this seemed like the beginning of the end. When the control buttons failed during a bar review session, I was very upset.

Booxtor, would you upgrade to the M92 from the M90, if you had no mechanical or physical failures of the unit? (The software/firmware aside - I've adapted to its idiosyncrasies.)
davidjoseph1 is offline   Reply With Quote