MobileRead Forums - View Single Post

jmseight · 04-24-2012, 05:22 PM

Hi,

Please see the photo of the cover I made. It was made from
http://www.amazon.com/gp/product/B00...ls_o06_s00_i00
that I originally bought for my Kindle.

I cut the horizontal strap because it interfered with the navi bar.

I had to cut the two vertical straps because they bulged out. The top strap bulges a little and I used a little bit of tape to hold it down.

I cut a hole in the back for the power switch, and finished it with a piece of the white vinyl from the horizontal strap.

I also cut the bottom strap a little bit to expose the USB port.

I later had to put two little spacers with the white vinyl on inside of the cover so the cover does not rub against the navigation bar when it is closed.

Thanks,
James

04-24-2012, 05:22 PM	#4
jmseight Zealot Posts: 130 Karma: 10000 Join Date: Mar 2012 Device: Kindle 3G, Kindle Touch 3G, iRiver Story HD, Sony Reader	Hi, Please see the photo of the cover I made. It was made from http://www.amazon.com/gp/product/B00...ls_o06_s00_i00 that I originally bought for my Kindle. I cut the horizontal strap because it interfered with the navi bar. I had to cut the two vertical straps because they bulged out. The top strap bulges a little and I used a little bit of tape to hold it down. I cut a hole in the back for the power switch, and finished it with a piece of the white vinyl from the horizontal strap. I also cut the bottom strap a little bit to expose the USB port. I later had to put two little spacers with the white vinyl on inside of the cover so the cover does not rub against the navigation bar when it is closed. Thanks, James Attached Thumbnails Last edited by jmseight; 04-24-2012 at 05:27 PM.