MobileRead Forums - View Single Post - Firmware updates, dictionaries, fonts and third-party software for M92

Mono · 03-09-2012, 08:55 PM

Booxtor didn't mean, that wrong on purpose calibration would fix your problem.

The aim was to find out if calibration does something (in your case). If you do it wrong on purpose, the result should be wrong (to the same extent). If you do calibration less wrong, drawing should be less wrong...

It is not easy to do calibration (at least in my case). Some points are easy, some difficult. Sometimes I have to try many times (more than 10-20) on one point.

I might do something in wrong way....

Anyway, at last everything works fine and pen writes quite precisely. Offset less than 1 mm (I guess).

----
What firmware do you have? I am not sure, but I think that 1.6 didn't use calibration at all or not suffitiently. 1.7 RC should be OK in this respect.

03-09-2012, 08:55 PM	#280
Mono Mono Posts: 699 Karma: 13333 Join Date: Jan 2012 Device: Boox M92	Booxtor didn't mean, that wrong on purpose calibration would fix your problem. The aim was to find out if calibration does something (in your case). If you do it wrong on purpose, the result should be wrong (to the same extent). If you do calibration less wrong, drawing should be less wrong... It is not easy to do calibration (at least in my case). Some points are easy, some difficult. Sometimes I have to try many times (more than 10-20) on one point. I might do something in wrong way.... Anyway, at last everything works fine and pen writes quite precisely. Offset less than 1 mm (I guess). ---- What firmware do you have? I am not sure, but I think that 1.6 didn't use calibration at all or not suffitiently. 1.7 RC should be OK in this respect. Last edited by Mono; 03-09-2012 at 08:59 PM.