|
but now still not updating?
784705] OmniVision ov7740 sensor driver, at your service
[ 3.433769] mmc0: new high speed SD card at address 2d91
[ 3.439554] mmcblk0: mmc0:2d91 SD02G 1.83 GiB
[ 3.444172] mmcblk0:
[ 3.887832] scsi 0:0:0:0: Direct-Access Benica SQ Card 0.00 PQ: 0 ANSI: 2
[ 4.075916] sd 0:0:0:0: [sda] 4014079 512-byte logical blocks: (2.05 GB/1.91 GiB)
[ 4.172156] sd 0:0:0:0: [sda] Write Protect is off
[ 4.221074] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 4.583389] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 4.589533] sda:
[ 4.680524] sda1
[ 4.949650] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 4.999849] sd 0:0:0:0: [sda] Attached SCSI removable disk
[ 6.514636] mmc1: new high speed SDIO card at address 0001
[ 15.466016] RAMDISK: gzip image found at block 0
[ 16.214119] RAMDISK: incomplete write (4926 != 32768)
[ 16.219214] write error
[ 16.438014] EXT2-fs (ram0): warning: checktime reached, running e2fsck is recommended
[ 16.445967] VFS: Mounted root (ext2 filesystem) on device 1:0.
[ 16.451981] Freeing init memory: 896K
[ 16.455994] Kernel panic - not syncing: No init found. Try passing init= option to kernel. See Linux Documentation/init.txt for guidance.
[ 16.468496] Rebooting in 1 seconds..
U-Boot 2009.01-rc1-svn1084 (Feb 15 2011 - 12:04:39)
Marvell version: 1.1.1.1 PXAxxx
ESI version: 2.0.3 (1) <<EdgeJr>>
MARVELL PXAXXX series.
Based on 88SV331xV5 Core with ARM926 LE CPU.
Code original base is u-boot-arm 2009.01-rc1.
DRAM: 512 MB
NAND: detect chip id d7ec on cs 0, Samsung 32Gibx8
SPI NOR: SF: Got idcode c2 20 17 c2 20
SF: Detected MX25L6405D with page size 256, total 8388608 bytes
In: serial
Out: serial
Err: serial
Net: u2o-eth
Hit any key to stop autoboot: 3
[08][08][08] 0
EdgeJr>>
|