[vicinc]

u clever than me
can not see anything on help that will help me correct the baddies
do you remember anything from here?
EdgeJr>> help
? - alias for 'help'
base - print or set address offset
bbt - Bad Block Management
bootz - boot zImge from memory
check mem
cmp - memory compare
cp - memory copy
crc32 - checksum calculation
help - print online help
hi - put system into hibernate mode
i2cbase - i2cbase i2c_base_addr (I2C: 0xd4011000, PI2C: 0xd4025000)
i2cinit - initialize i2c bus
i2cr - read I2C device (byte)
i2cw - write I2C device (byte)
i2cwa - write addr to I2C device (byte)
loop - infinite loop on address range
machine_id - change machine id
md - memory display
mm - memory modify (auto-incrementing)
mtest - simple RAM test
mw - memory write (fill)
nand - NAND sub-system
nm - memory modify (constant address)
op - operating change
ping - send ICMP ECHO_REQUEST to network host
printenv- print environment variables
reset - Perform RESET of the CPU
run - run commands in an environment variable
saveenv - save environment variables to persistent storage
setenv - set environment variables
sf - SPI flash sub-system
switch -switch the download by USB or Ethernet, and config conresponsed IP
tftpboot -download image via network using TFTP protocol
version - print monitor version