Quote:
Originally Posted by FSD08
-----------------------------------------------------------------------
The PE I set up for our daughter is up and running Ermine 0.9 without a problem as far as I can see. I am now setting up the other PE and have updated to Ermine 0.9 from Dingo 1.6, I thought without a problem, until the calibration target appeared on the reader - this was after the system had been up only about a minute or two - long enough to turn off automatic updates. This would not go away until I pressed the "switch documents" button a few times. I then tried to calibrate the display from the settings menu and no luck. I also tried to open a book, with no luck. My next step was to down grade to Dingo 1.6 which worked flawlessly - as far as I could tell. The reader worked, the display worked, etc. I then upgraded to Ermine 0.9 - again and the same thing happened. My next thought was to install the user modded update, but I thought I would place this post prior to that, as I don't want to turn the PE into a brick. I forgot to mention that in neither of the Ermine installations was I able to calibrate the touch screen. Any suggestions you might have will be most appreciated.
Thanks in advance
|
I solved dthe problem, I saw in another search that the stylus for the PE is not an ordinary stylus. Using the PE stylus everything worked and now both screens are calibrated on each of the PEs ZI set up. The only problem left is that the one our daughter did not want she has decided to keep vs a iTouch with 8GB for $189 - a good choice. So I ran out and got a 7" Kryos by COBY for $90. While it works the PE is BY Far a better unit. Thanks dfor all of your help. In the meantime, I'm looking for a reasonably priced PE.