Thread: shell access doesn't install
View Single Post
Old 05-08-2008, 07:38 PM   #2
-Thomas-
Addict
-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.
 
-Thomas-'s Avatar
 
Posts: 325
Karma: 1725
Join Date: Dec 2007
Location: Münster, Germany
Device: iRex iLiad v2
If you can unbrick your iLiad the developer's package is installed correctly:

Quote:
Originally Posted by Adam B.
  1. Make sure your iLiad is powered off, with nothing on the screen.
  2. Hold the connect button in the upper right hand corner of your iLiad.
  3. While holding the button, press the power switch on the bottom.
  4. Count to Five while continuing to hold the button.
  5. Release the connect button.

You should see the boot image appear. After a second or two, the whole screen will flash white, and it will start to boot normally. Congratulations! Your iLiad is able to (be reflashed) / run third party applications.
That's from Adam's "How to unbrick (reflash, restore, etc) your iLiad"
-Thomas- is offline   Reply With Quote