Thread: Travel Hub
View Single Post
Old 09-01-2011, 02:12 PM   #26
janzen
Member
janzen knows the difference between 'who' and 'whom'janzen knows the difference between 'who' and 'whom'janzen knows the difference between 'who' and 'whom'janzen knows the difference between 'who' and 'whom'janzen knows the difference between 'who' and 'whom'janzen knows the difference between 'who' and 'whom'janzen knows the difference between 'who' and 'whom'janzen knows the difference between 'who' and 'whom'janzen knows the difference between 'who' and 'whom'janzen knows the difference between 'who' and 'whom'janzen knows the difference between 'who' and 'whom'
 
Posts: 15
Karma: 10000
Join Date: Jul 2011
Device: iLiad
My iLiad came complete with all its cables so I was able the measure with an Ohmmeter the pins of the original connecter that were used for power and data respectively. Then I soldered one new connector to one end of a short piece ( abt 3”) of cable at the other end of which I soldered a female low voltage socket that fits to the male plug of the power adapter. I did the same with a piece of an ordinary USB cable to which I soldered the 2nd connector. Unfortunately I lost my notes of the 20 pin layout of the connectors. Needless to say that you can blow the reader if you make a mistake. I remember I found in my situation some discrepancies with Snoopy ’s layout in post 1 of this thread.
janzen is offline   Reply With Quote