MobileRead Forums - View Single Post

MasterTec · 07-18-2011, 12:44 PM

OK so I installed Chainfire3d 2.8 and now my PE won't boot. I've tried reverting to ermine and I've tried doing the factory restore (with dingo). Doing either shows the "updating" screen for about five seconds and then nothing.. it just hangs on the Pocket eDGe boot screen for about 10-15 minutes and then goes blank.

This may have something to do with my renaming my phone.apk and telephony.apk files. I didn't think Chainfire would brick this because others have installed it without problems.

I was reading the other unbricking thread and they mentioned restoring the build.prop file and while I don't think that is the case with me, I'd like to at least find a way to access the phone/telephony.apk files and rename them. Maybe it'll take a restore once I do that.

I can connect the USB to my PC and it shows two drives on my PE but I cannot access them (please insert disk type message). So where do I go from here? How do I access the file system on my PE?

07-18-2011, 12:44 PM	#1
MasterTec Connoisseur Posts: 98 Karma: 14416 Join Date: Jul 2011 Device: enTourage eDGe Pocket	Unbricking for dummies OK so I installed Chainfire3d 2.8 and now my PE won't boot. I've tried reverting to ermine and I've tried doing the factory restore (with dingo). Doing either shows the "updating" screen for about five seconds and then nothing.. it just hangs on the Pocket eDGe boot screen for about 10-15 minutes and then goes blank. This may have something to do with my renaming my phone.apk and telephony.apk files. I didn't think Chainfire would brick this because others have installed it without problems. I was reading the other unbricking thread and they mentioned restoring the build.prop file and while I don't think that is the case with me, I'd like to at least find a way to access the phone/telephony.apk files and rename them. Maybe it'll take a restore once I do that. I can connect the USB to my PC and it shows two drives on my PE but I cannot access them (please insert disk type message). So where do I go from here? How do I access the file system on my PE?