I was having the same problem as pyxiwulf, finally got to the "Updating Software" screen...where it got stuck for 30+ minutes. After hitting reset again to get out of that (holding the power switch had no effect), I tried a second time with that flash drive (the first flash drive was apparently not recognized) and it moved past the "Updating Software" screen...only to get stuck back at three dots like the problem I started with. Help!
I don't know if it is relevant, but before I got stuck here with my PE, I had to turn it off by holding the power switch because it froze. The cause of the freeze was inconsistent. I had no problem starting it back up after any of those forced power downs. After turning it off "properly" (hold down rotate and select power down), it would not power back up, I just got stuck at those three dots.
Any ideas? I had just started to rely on this little device when it pulled this stunt.
