Quote:
Originally Posted by Utahcowboy
ruber feet? If you mean the place where the usb and headphone jack are, there isn't a screw there.
I did undo the screws under the battery cover, but I couldn't figure out how to pop it open to look and see if I could fix it myself.
|
Sorry... On my engineering sample unit, the three other places were covered with enough rubber (on the back of the unit) to portrude beyond the metal case - I called them 'feet'. On my current version, there's only enough 'rubber' to cover the screw heads. One is down on the left edge - as seen from the rear - just below the level of the two volume control buttons ("+" and "-"). Another is just to the right of the Power On/Off button and the third is along the right edge, below the lower edge of the stamped 'SD card' image which happens to be below the SD card slot. And then there is the screw within the battery compartment. That gives a total of four screws to remove.
Of course, removing the 'rubber' patches is probably going to be damaging enough to the 'rubber' as to negate any possibility of re-inserting them after you re-attach the screws.
Derek