MobileRead Forums - View Single Post

jekvb · 06-05-2011, 04:17 PM

Hello everyone!

When my iRex DR1000s starts up, it does not mount the 2GB SanDisk, so it subsequently cannot read "system" and everything that is in it.

Sometimes the sytem will mount the SanDisk after an reset to factory defaults, but the mount dies after 1 to 2 minutes.
The SanDisk itself, or the filesystem on it, does not seem corrupt since I have no problem mounting it on my notebook, which has a Fedora linux filesystem.

This behavior started after I copied an update directoy into "system".
Can somebody point me in the right direction in getting this to work again?

Thanks & regards, Kuba

06-05-2011, 04:17 PM	#1
jekvb Connoisseur Posts: 52 Karma: 90 Join Date: May 2011 Device: PocketBook Inkpad 3 Pro; Android: PocketBook & ReadEra	SanDisk does not mount Hello everyone! When my iRex DR1000s starts up, it does not mount the 2GB SanDisk, so it subsequently cannot read "system" and everything that is in it. Sometimes the sytem will mount the SanDisk after an reset to factory defaults, but the mount dies after 1 to 2 minutes. The SanDisk itself, or the filesystem on it, does not seem corrupt since I have no problem mounting it on my notebook, which has a Fedora linux filesystem. This behavior started after I copied an update directoy into "system". Can somebody point me in the right direction in getting this to work again? Thanks & regards, Kuba