[3dsign]

Please help me. I received the PRS 600 just today and while going through this forum was tempted to try the PRS+.

1)I went to the project site and according to the install guide, extracted the PRSP_600_base_flasher_1.0_by_amutin.zip to the root of the internal memory.

2)Then I restarted the reader as per the instructions. Nothing seemed to happen and I was greeted with the same default screen.

3)Then I connected the reader to the pc and after the storage was detected, I clicked runme.bat from the reader internal memory. A command prompt opened and a window came up saying updater.exe has stopped functioning. I clicked cancel. I removed the cable and reconnected.

4) Since then it is saying "Firmware update did not complete successfully. Please try again."

5) Worst part is, I cannot seem to turn it off to reboot or try hard reset. It just sits with the "Reader" logo on the screen and the failed update message below it.

Please help me out. I havent even read a single ebook on it and i just feel like crying right now. ;'(

Is the device bricked forever? Is there something I can do to reinstate it? I request the devs of the firmware to please help me out. I'm sure you guys must've come across an issue like this.

Awaiting your response.

Please save my reader. I'll be grateful to you for life. :'(


Thanks,
Karen