Ok. I've been trying to help hswang6802 out over the past few days, but I've been busy enough I cannot check this forum daily. So here's a little rundown to get you into troubleshooting mode...
When you connect the WG to the computer, it must be plugged into a wall outlet and you also have to select "Connect to PC"
To get to that option, if you haven't found it already, you should change the language to English (unless you can read Japanese), this is located under the wrench icon. You need to swipe your thumb to the left when holding the device with the round end to your left for select.
Once both cables are connected and you select "Conn...," the device should show up as a SD-card device and Windows will read any card you thro into it. I'm using a 128MB in there now, but I used a 512MB previously, both SanDisk standard el' cheapo cards.
Once it's recognized you need to just poke and play around with the button in the My Bookshelf software you said you've already successfully installed.
Note: I just plugged mine in to test it and make sure Windows could see it without having to run the My Bookshelf software. Good luck & have fun experimenting with it!
|