Quote:
Originally Posted by speakingtohe
Try a different USB port or safe mode.
or
TRy right clicking on each folder on the H: drive in my computer and select properties.
This should tell you if any or all files are read only
If read only is checked or colored click in little box till it is clear. Click apply.
|
Thank you all for these replies.
I tried safe mode and plugged into a different USB, two different computers actually, with no luck.
I checked the properties to find that the folders were indeed switched to "read only," but I get an error when I try to make a change. I am told that the "parameter is incorrect" or "Data Error: cyclic redundancy check."
I'm beginning to suspect that the device is defective. I've never dealt with such a fussy little POS.
