Hi All,
I've just taken the plunge and replaced the battery on my 505. Everything went according to plan and the battery is now fully charged. However, when I turn the reader on it starts up OK and displays the main menu but is unresponsive from thereon. The only buttons which seem to work are the power and the volume.
A short reset has no effect. When I try a hard reset, following the Wiki instructions here, it gets as far as the 'start-up' screen but holding the 'Mark' and 'Vol+' buttons doesn't bring up the 'Reset' screen - it gets up to the main menu again but remains unresponsive thereafter.
I've displayed the contents in Calibre and successfully deleted a book, as a test. This seemed to work OK as far as Calibre is concerned, but I have no idea about the Reader itself because when I unplugged it and it started up again, it still froze on the menu. I cannot access the 'settings' menu to shut it down - I can only switch off via the power button on top.
My next stage seems to be a full re-format but I need to have some firmware to reload. I've been onto the Sony site and see the update firmware is available - is this all I need or does this only update the basic operating software which is already there? Does anyone know where I can find the complete software which will work from scratch, please?
Has anyone got any other suggestions about how to get it working without doing a full re-format?
It was working fine before the battery change, so I suspect I've done something wrong, even though I followed the online video instructions as I went along.
Any ideas gratefully received!
Thanks,
Chris