|
Dear Kartu,
Thank you. So I connect my 950 using usb, copy the exe file over to the root (parent) directory, switch off the 950, switch on the 950, then the 950 boots up using your setup.exe file and that's it? Is it as simple as this?
The wiki says this:
350 / 650 / 950
Simply use corresponding "...setup.exe". (Updates could also be installed manually by unpacking PRSPInstaller into internal memory and restarting the reader, as with 600. You will also need to unpack boroda or amutin launcher into internal memory, depending on firmware that you have.)
The stuff in parentheses was hard to follow and I think applied to your earlier versions, when no base flasher.
Thank you for your work - I know you did an incredible amount and may be tedious to go back and change all the instructions, also when you are writing for so many machines.
best regards
|