MobileRead Forums - View Single Post - PRS-350 Case suggestions: non-bulky

elizilla · 02-13-2011, 12:36 AM

I have my 350 in an M-Edge case that was built for a 300, too. I think it's likely the same one. It zips to close all the way around, yet it folds over on itself for reading - this is a combination that's rarer than it should be.

The case is loose, but the straps at the edge do still hold it somewhat. I haven't decided whether I will prefer to take it out when I read, so I haven't added velcro to firm up the hold. It's good enough for now. And it's not very bulky, though it would be even less bulky if it fit the 350 a bit better.

They're not expensive and they come in bright colors. It'll do, until I find something I like better, if I find something.

02-13-2011, 12:36 AM	#10
elizilla Addict Posts: 271 Karma: 610286 Join Date: Nov 2010 Location: Michigan, USA Device: Kobo Elipsa, Kindle Paperwhite, Kobo Sage, others	I have my 350 in an M-Edge case that was built for a 300, too. I think it's likely the same one. It zips to close all the way around, yet it folds over on itself for reading - this is a combination that's rarer than it should be. The case is loose, but the straps at the edge do still hold it somewhat. I haven't decided whether I will prefer to take it out when I read, so I haven't added velcro to firm up the hold. It's good enough for now. And it's not very bulky, though it would be even less bulky if it fit the 350 a bit better. They're not expensive and they come in bright colors. It'll do, until I find something I like better, if I find something. Last edited by elizilla; 02-13-2011 at 12:38 AM.