Quote:
Originally Posted by mbelec
I bought a new PRS-600 cover on ebay for $8.95, carefully lifted the clip bar from the case, removed approx. 8-10 mm from the bar with scissors, cut off the extra plastic 'lumps' (that sat down inside the case) on the bar, then reglued it to the cover with gorilla glue. The 650 is a little smaller overall than the 600, but I like how it sits inside the cover with about 8-10 mm extra; it feels more protected.
|
Be careful with the Gorilla glue, its a moisture cure polyurethane that might not strongly bond to polypropylene or polyester - you might get some extra adhesion by scratching the back of the plastic with sandpaper but PP and PET are notoriously hard for a glue to bond strongly to. I wouldn't want you to be carrying your Sony by the case and the holding clip peels off dropping it to the floor.
If it does fall off another option would be to get some small pop rivets from radio shack, you'd have to drill though the cover but it should look reasonable if you paint the pop rivets black.
Good luck
Masrock
