Quote:
Originally Posted by dameuna
Thanks,
I downloaded the latest firmware. This will be the first time I am upgrading firmware from a SD card and I want to make sure I do it right. I would appreciate it if you would tell me if the following is correct. It sounds like you were able to upgrade with no problem.
Jinke says: "Unzip the update pack, and copy unzipped files into the boot index of SD card. (a. The storage of the SD card should be less than 512MB; b. The SDcard should be FAT 16.)"
--- So it seems that I need to purchase a 256 SD card, since the V3 came with a 512MB. Correct?
|
I just used the 512MB card that came with the V3 and it was fine. I guess it is just a typo and they may probably meant less than or equal to 512MB.
Quote:
Originally Posted by dameuna
--- When I purchase the card, will it be in FAT 16, or do I need to re-format it?
|
I just used the 512MB card as mentioned and didn't try any formatting.
Quote:
Originally Posted by dameuna
--- By "into the boot index", do they mean just put the bin file into the root directory (not in a sub-directory)? Can other files or directories be on the card or must it be empty?
|
Yes, just put it in the root directory. No need to delete other files. You will lose your bookmarks however, so you might want to make a note of them.
Quote:
Originally Posted by dameuna
Then they say: "Hold to press V+ button (which is on the top of the right side of the device),switch on the device"
--- By "V+ button", I assume they mean the "Volume Up button", correct?
|
Correct.