Quote:
Originally Posted by jhempel24
I've followed all the instructions, and have even done this on my nook, well I'm trying to do the same to my wife's.
I have 1.0.0 firmware on the unit, but it will NOT launch, it goes from checking for updates, to re-boot, and back to 1.0.0
Could my external SD Card not be formatted right?
Thanks!
|
Query: do you have any non-Microsoft machines that have touched the SD card? Reason I ask is that I have seen almost exactly the same scenario WRT SD cards and the CoolER. The problem came down to this: Most if not all "preformatted" SD cards come with FAT16 or so but more importantly, there is no proper partition table on the disc; its like they slammed the FAT partition onto the disc w/o doing the low-level stuff first. Because Microsoft basically ignores this, most apps that expect FAT on the SD card (or USB key or...) don't either and some even depend upon that to work. CoolER with Linux on-board even) was just such a beast. I needed to up the firmware on it but if I had a device that I have set up a proper partition table on for FAT and then formatted the partition and then put the firmware on, it would fail to boot the CoolER even though all Windows boxen could read it and all non-Windows boxen could say "Yep, its FAT16 (or whatever)". If I just bought a pre-formatted one from the corner store, slapped the firmware on that it was good to go....