Quote:
Originally Posted by Desertway
I have the Firmware folder on the root of the SD card. I reset the Libre. I press the > and power button together. All I get is the Aluratek splash page. I pressed these keys for about 5 minutes and never got the picture of the trashcan that the instructions indicate. I'm upgrading from 0.15v. Any advice? Thanks.
|
OK, in an attempt to duplicate yer fail, science, ya know
, I tried pressing the
power button and the '>' key ten times before getting the firmware update screen. Apparently, the last two upgrades I've gotten it by sheer luck in 3 tries.
After a lil fiddling I have determined the following: 1) press the '>' key and hold.
2) press the power button for no more than 2 seconds while continuing to hold down the '>', release the power button after two secs. 3) continue holding '>'
for 6 additional seconds, I say 6 because I was saying one, one thousand
two one thousand... and it took me to six one thousand for timing.
This works everytime, I did it three times in a row.
Regards, mark