I am currently running 1.71 and I didn't try the new firmware yet. As I say, I am going to hold off (there were mentions of the firmware being defective on the website you linked to).
As for your problem with the freezing, I don't think I can help. Mine has been working perfectly since I got it, and I hardly have any issues with it. I have reset it only a couple of times in what, six months.
I would hold out for a firmware upgrade. Either try the new one (very risky) or wait patiently for the next upgrade.
Alternatively this was my advice in another thread:
Quote:
I have not found any easy steps to fixing your problems. My suggestions are either wait for somebody to reply on Ivo's blog or investigate this page http://openinkpot.org/wiki/Device/Story and go ask at the openinkpot IRC http://irc.openinkpot.org/%23openink...03-18.log.html
*hint - there are some instructions on running arbitrary code in the samplecode.zip file. Be careful though, because if you don't know what you are doing, you'll probably make it worse.
|