Quote:
Originally Posted by theducks
Someone posted a link (you?) a while back on how to replace the screen in the 6".
|
Not me.
Quote:
Originally Posted by theducks
One of the steps was to note a hand written number on the new display and run a special program to configure the display properties to match the current fitted display. (I believe there was a resistor change also. )
Did the forget this step (or equivalent) in production of the V5?
|
I think that you are probably referring to the "waveform calibration file" that optimizes the controller operation to the characteristics of a particular batch of e-Ink screens. I am pretty sure that optimization is way off on my particular PocketPRO, which is why I mentioned poor quality control. There are several other things wrong with my PocketPRO, including thoroughly peeled paint, bum USB, and flaky SD card operation, that make me think that I just got a lemon when I purchased my PocketPRO. My 6" EZReader is so much better in all those aspects that it is the one that I use the most. I just use the PocketPRO for a traveling reader, and I can get by with that OK.