|
Hi Kovid
I hope I did this right - I'm not very knowledgeable. I put calibre-debug -g in the command prompt and the following came up:
link hasn't been detected!
link hasn't been detected!
Job: 1 Get device information finished
No details available.
Job: 2 Get list of books on device finished
No details available.
I did notice that it returned Calibre to version 0.6.16 with the tag browser and cover browser working. I reinstalled 0.7.10 - choosing to run the repair programme offered, and ended up with the situation I was in when I first emailed you. I have rerun the command prompt and now have 0.6.16 loaded again.
I hadn't realised when I emailed before that there is also something funny going on with the recognition of my device. Although, when my device was connected I could see in the library window which books are loaded on it, when I tried to send a new book I had a message that no device was connected. I was able to send a book to my device using the save to disk button.
I hope this extra information is helpful.
Thank you
Rachel
|