View Single Post
Old 07-17-2010, 09:55 AM   #4
leidola
Junior Member
leidola began at the beginning.
 
Posts: 7
Karma: 10
Join Date: Jul 2010
Device: Hanvon N516
Seems as if i had a similar problem.
First of all I tried 0.2.1 for n516. Flashing worked fine (I think) but when resetting the device nothing showed up, the blue light glowed with full intensity.

It took me a while to find out how to get the device into a reflashable state (blue light glowing weakly), but I found out that holding reset and rotate while usb is connected seems to do the trick.

Then I tried 0.3-current. As the original poster I noticed 6 bad blocks where reported after running nerase. Yet, nprog mentioned 0 bad blocks when being run.

I followed strictly the README file.

I noticed the option -o of nprog. Trying this one. But the message cannot connect device appears on every step and it seems to increase the bad block count. Can this be resetted?
leidola is offline