|06-10-2010, 01:39 PM||#1|
Join Date: Jun 2009
Location: The Far East
Device: PRS 600
I just recently got the wall charger for my PRS-600. Prior to this I was only using the usb charger... which was horrible.
However, after about 3 weeks of use, the wall charger is not doing so good either. This past 1 week, no matter how long I leave the charger plugged in, the reader will not go above 1 bar. And after a very short time of reading it goes to 0 bars and will give me the low battery warning. I have no idea what is going on.
Any suggestions? Should I just try to get it replaced?
|06-10-2010, 05:03 PM||#2|
Join Date: Sep 2009
Location: Utrecht, the Netherlands
Device: Kindle Paperwhite 2
It could be a faulty charger, do you know someone who has a PSP charger you can borrow to see if the PRS600 will charge with that?
Did you get the official charger or did you buy a cheap PSP charger? If you have an non-Sony charger you might want to check the voltage (5V or better 5,2V) and the Amps (the higher the quicker it charges, don't know what's the minimum for the PRS).
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|battery problem||oleg||Astak EZReader||4||09-08-2010 04:32 PM|
|Battery Problem?||gordoncanada||Ectaco jetBook||10||02-12-2010 02:24 PM|
|PRS-500 battery problem, but the battery's not the problem||ZachC||Sony Reader||7||01-11-2010 11:46 PM|
|battery problem||asdx||Sony Reader||3||07-21-2009 12:43 PM|
|Battery problem?||Aprilbeginnings||Sony Reader||39||01-06-2007 10:30 AM|