12-31-2009, 06:12 AM | #1 |
Connoisseur
Posts: 60
Karma: 12
Join Date: Dec 2009
Device: EzReader
|
tried it
Hi
I tried in on my Astak V3 and it was very slow. Is that normal ? I know it is very new but not sure if it should have run that slow. Booting was a minute and just moving around the menus was very slow. I am guessing much more intensive on my 200mhz processor then Astak's firmware. |
12-31-2009, 08:06 AM | #2 |
What Title ?
Posts: 1,325
Karma: 1856232
Join Date: Jan 2009
Location: Bavaria Germany
Device: Sony Experia Z Ultra
|
|
Advert | |
|
12-31-2009, 08:40 AM | #3 |
Connoisseur
Posts: 60
Karma: 12
Join Date: Dec 2009
Device: EzReader
|
I tried oi-hanlin-v3-install-0.2.zip
|
12-31-2009, 08:55 AM | #4 |
What Title ?
Posts: 1,325
Karma: 1856232
Join Date: Jan 2009
Location: Bavaria Germany
Device: Sony Experia Z Ultra
|
Unless you have a VERY old Hanlin V3 (< 2008), then you have the wrong firmware.
If you have a newer Hanlin V3 (512MB), you need oi-hanlin-v3ext-install-0.2.zip http://openinkpot.org/wiki/0.2/InstallationGuide |
12-31-2009, 09:23 AM | #5 |
Connoisseur
Posts: 60
Karma: 12
Join Date: Dec 2009
Device: EzReader
|
wow
ok... I will try it again with the correct firmware |
Advert | |
|