Register Guidelines E-Books Search Today's Posts Mark Forums Read

Go Back   MobileRead Forums > E-Book Readers > More E-Book Readers > iRex

Notices

Reply
 
Thread Tools Search this Thread
Old 05-07-2008, 12:41 AM   #1
bryancostanich
Junior Member
bryancostanich began at the beginning.
 
Posts: 3
Karma: 10
Join Date: May 2008
Device: Iliad
shell access doesn't install

hey all,

i went to the shell access page, requested access, then connected to IDS, it downloaded the shell access and unpacked it. but i don't think it ran, as i can't run any installs. when i click on them, the screen flashes and then just goes back.

is there a way to verify that it installed correctly?

-b
bryancostanich is offline   Reply With Quote
Old 05-08-2008, 07:38 PM   #2
-Thomas-
Addict
-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.-Thomas- once ate a cherry pie in a record 7 seconds.
 
-Thomas-'s Avatar
 
Posts: 325
Karma: 1725
Join Date: Dec 2007
Location: Münster, Germany
Device: iRex iLiad v2
If you can unbrick your iLiad the developer's package is installed correctly:

Quote:
Originally Posted by Adam B.
  1. Make sure your iLiad is powered off, with nothing on the screen.
  2. Hold the connect button in the upper right hand corner of your iLiad.
  3. While holding the button, press the power switch on the bottom.
  4. Count to Five while continuing to hold the button.
  5. Release the connect button.

You should see the boot image appear. After a second or two, the whole screen will flash white, and it will start to boot normally. Congratulations! Your iLiad is able to (be reflashed) / run third party applications.
That's from Adam's "How to unbrick (reflash, restore, etc) your iLiad"
-Thomas- is offline   Reply With Quote
 
Enthusiast
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Problem getting shell access templario iRex 1 03-17-2008 10:25 PM
iLiad Can't Connect via USB after Dev Access Shell Install jfrey iRex Developer's Corner 4 02-20-2008 12:20 PM
Can't get shell access MarkRPenn iRex 11 10-26-2007 06:58 PM
Shell Access ? grayfox iRex 6 10-14-2007 04:56 PM
iLiad Shell access package HarryT iRex Developer's Corner 3 08-07-2007 08:07 AM


All times are GMT -4. The time now is 02:11 PM.


MobileRead.com is a privately owned, operated and funded community.