shell access doesn't install

[bryancostanich]

hey all,

i went to the shell access page, requested access, then connected to IDS, it downloaded the shell access and unpacked it. but i don't think it ran, as i can't run any installs. when i click on them, the screen flashes and then just goes back.

is there a way to verify that it installed correctly?

-b

[-Thomas-]

If you can unbrick your iLiad the developer's package is installed correctly:

Originally Posted by Adam B.

1. Make sure your iLiad is powered off, with nothing on the screen.
2. Hold the connect button in the upper right hand corner of your iLiad.
3. While holding the button, press the power switch on the bottom.
4. Count to Five while continuing to hold the button.
5. Release the connect button.

You should see the boot image appear. After a second or two, the whole screen will flash white, and it will start to boot normally. Congratulations! Your iLiad is able to (be reflashed) / run third party applications.

That's from Adam's "How to unbrick (reflash, restore, etc) your iLiad"