MobileRead Forums - View Single Post - Help for Noob on installing Open Inkpot on Hanvon ereader

overflo · 05-09-2010, 08:34 PM

Thanks for the reply.
I wasn't holding both the power and rotate button. Now that I am, though, the blue light comes on but only at half the brightness as when normally powered up and nothing else happens, and now no device shows up. To get it out of this state I need to reset the device.

If anyone has any experience with the installing OPenInpot on the Hanvon N516 I'd appreciate some advice. I bought the Hanvon for my Dad who needs large print when reading, that's why I went for the Hanvon, it was the only one available to me (here in West Australia) that is compatible with OpenInkpot.

Cheers

05-09-2010, 08:34 PM	#5
overflo Junior Member Posts: 8 Karma: 10 Join Date: May 2010 Device: Hanvon n516	Boot up Thanks for the reply. I wasn't holding both the power and rotate button. Now that I am, though, the blue light comes on but only at half the brightness as when normally powered up and nothing else happens, and now no device shows up. To get it out of this state I need to reset the device. If anyone has any experience with the installing OPenInpot on the Hanvon N516 I'd appreciate some advice. I bought the Hanvon for my Dad who needs large print when reading, that's why I went for the Hanvon, it was the only one available to me (here in West Australia) that is compatible with OpenInkpot. Cheers