MobileRead Forums - View Single Post - PRS-T2 stuck on opening book!

Stefan_v · 04-20-2013, 04:37 PM

Hi there,

Just last week I unpacked my brand new PRS-T2. Today I connected it to my USB of my MacBook Pro to put some books on it with the reader software.

The reader software said a new update was available 1.005.12140 (EU), so I read the release notes on http://www.sony.nl/support/nl/produc...v1005_12140_EU
and just went ahead.

It downloaded the update and did it's 'thing'.

After a few minutes it went into the boot state 'opening book' but it does not do anthing anymore. The reset procedure keeps ending in the same screen.

I connected it to a windows system, but it is not recognized there. And the same screen.

I search the Internet and this forum, but I could not find anything related specifically to the T2.

I tried hard en soft resets but it does not work.
It can not power it down.
As of my knowing it was fully charged.

Any thoughts someone ?

regards,

Stefan V

04-20-2013, 04:37 PM	#1
Stefan_v Junior Member Posts: 2 Karma: 10 Join Date: Apr 2013 Device: PRS T2	stuck on opening book! Hi there, Just last week I unpacked my brand new PRS-T2. Today I connected it to my USB of my MacBook Pro to put some books on it with the reader software. The reader software said a new update was available 1.005.12140 (EU), so I read the release notes on http://www.sony.nl/support/nl/produc...v1005_12140_EU and just went ahead. It downloaded the update and did it's 'thing'. After a few minutes it went into the boot state 'opening book' but it does not do anthing anymore. The reset procedure keeps ending in the same screen. I connected it to a windows system, but it is not recognized there. And the same screen. I search the Internet and this forum, but I could not find anything related specifically to the T2. I tried hard en soft resets but it does not work. It can not power it down. As of my knowing it was fully charged. Any thoughts someone ? regards, Stefan V