Thread: Instructions for patching firmware 3.3.x, 3.4.x, 3.5.x
View Single Post
Old 04-25-2014, 02:53 PM   #19
SHunter101
Connoisseur
SHunter101 really knows where his or her towel isSHunter101 really knows where his or her towel isSHunter101 really knows where his or her towel isSHunter101 really knows where his or her towel isSHunter101 really knows where his or her towel isSHunter101 really knows where his or her towel isSHunter101 really knows where his or her towel isSHunter101 really knows where his or her towel isSHunter101 really knows where his or her towel isSHunter101 really knows where his or her towel isSHunter101 really knows where his or her towel is
 
Posts: 56
Karma: 70350
Join Date: May 2013
Device: Kobo AuraH2O, Glo, AuraHD, JBC2
Quote:
Originally Posted by tshering View Post
I tried again with both line spacing patches. And both run without error. Is it possible that something happened to your configuration file, or that you use a libnickel.so.1.0.0 that has already been modified?

Edit: Since the error is at 676F68, I wonder why GeoffR writes twice at this point:
Code:
replace_bytes = 676F68, 86 EE 1D A3 D3 E9 00 23, 00 00 00 00 00 00 F0 3F
...
replace_float = 676F68, 1.0,  0.7
But this does not explain, why it is working for me, and not for you. Or did you by chance change one of these two lines? Since this would result in an error.
Hi Tshering:

Both config files I used were unmodified. The libnickel.so.1.0.0 file was also unmodified; and no lines were change. I am not sure what the problem is. Removal of both 10 and 15 line spacing code does allow the program to generate the KoboRoot.tgz file.

Shunter
SHunter101 is offline   Reply With Quote