|
Thanks for the trouble, Matthias. I am wondering if it is "just" the firmware (assuming this includes the Linux installation with the apps installed)?
I have set the margins per your advise. Keeping level 0 for the glyph gives a more overall impression of sharpness, although too many character become very thin on one or more sides (top and bottom of the 'o'; left part of the 'A'; etc). This thinness is reduces when going to level 2 for the glyph setting, but it takes a little bit of sharpness away.
Starting on page 7 the left margin is almost perfect to the uttermost left of the display. Switching to the next page: ok; switching to again the next page and there is a margin (this is the table 1 page). Now going back and the previous page also has a margin. Back ones more and the margin is gone, an the letters seem to be a tiny bit larger with more interline space.
Continuing forward, the page with Figre 4 on it uses the full width of the display again, after which the above seems to start again.
Do you experience the same irregularities?
|