MobileRead Forums - View Single Post - Reader stuck after partial firmware update

wpaley · 02-14-2007, 01:40 AM

During the firmware update (I am using Parallels on a MacBook & XP by the way) a message said it could not complete the update. My Reader screen is stuck at "Updating firmware now..." I've tried resetting and even hard reset but all I get is that screen or "Firmware update is not finished correctly. Please execute firmware update again." when I disconnect it from USB. I've downloaded the update and tried, but it fails to complete. CAN I GET IT BACK TO ORIGINAL THE FIRMWARE? CAN I HARD RESET? HOW?

02-14-2007, 01:40 AM	#1
wpaley Junior Member Posts: 4 Karma: 21 Join Date: May 2005 Device: treo 650	Reader stuck after partial firmware update During the firmware update (I am using Parallels on a MacBook & XP by the way) a message said it could not complete the update. My Reader screen is stuck at "Updating firmware now..." I've tried resetting and even hard reset but all I get is that screen or "Firmware update is not finished correctly. Please execute firmware update again." when I disconnect it from USB. I've downloaded the update and tried, but it fails to complete. CAN I GET IT BACK TO ORIGINAL THE FIRMWARE? CAN I HARD RESET? HOW?