MobileRead Forums - View Single Post

bko · 11-08-2014, 05:15 PM

Hello,

I have an Onyx Boox C65 After Glow (ArtaTech, Amazon) and wanted the "original" - Onyx Software Int flash because it also has Google Play so doing.
Have both RK Android Flash Tools v1.35 and v1.37 used. Flashing process completes without any error message, drivers were installed automatically (The device is reported on Win7 than -USB mass storage device and 2x as Onyx Int iBoox USB device, the Explorer will be two empty removable storage devices, Reader turns on after a minute, ie, display lighting going on - and that's that!
The message: "AG is your BOOX off" allas is what you can read. No boot, nothing ...

I have several times the whole procedure (delete the NAND (Idb), bottles of - kernel.img, boot.img, misc.img, backup.img, recovery.img and system.mg) with ROOMs of Onyx Int. and ArtaTech (alternately) performed, but only the light goes on and it does not boot.

Curios there is also this: I've done the same thing about 3 months ago. Back then everything went back wonderful, from Arta to Onyx Int and again. Without problems.

What have I done wrong now?

Am grateful for any help!

(Sorry for bad english. It is a Google translation.)

11-08-2014, 05:15 PM	#5
bko Junior Member Posts: 2 Karma: 10 Join Date: Nov 2014 Device: M92	Onyx Boox C65 revive? Hello, I have an Onyx Boox C65 After Glow (ArtaTech, Amazon) and wanted the "original" - Onyx Software Int flash because it also has Google Play so doing. Have both RK Android Flash Tools v1.35 and v1.37 used. Flashing process completes without any error message, drivers were installed automatically (The device is reported on Win7 than -USB mass storage device and 2x as Onyx Int iBoox USB device, the Explorer will be two empty removable storage devices, Reader turns on after a minute, ie, display lighting going on - and that's that! The message: "AG is your BOOX off" allas is what you can read. No boot, nothing ... I have several times the whole procedure (delete the NAND (Idb), bottles of - kernel.img, boot.img, misc.img, backup.img, recovery.img and system.mg) with ROOMs of Onyx Int. and ArtaTech (alternately) performed, but only the light goes on and it does not boot. Curios there is also this: I've done the same thing about 3 months ago. Back then everything went back wonderful, from Arta to Onyx Int and again. Without problems. What have I done wrong now? Am grateful for any help! (Sorry for bad english. It is a Google translation.)