Solved! - details of the problem and solution in the posts below:
Hello,
I rooted my PRS-T1 reader with rupor's
AMR. After that I tried a
hard reset.
Then the reader stopped loading. Description:
http://www.youtube.com/watch?v=F36UR...&feature=g-upl
In words: The device load the "opening book" screen. After the bar finished loading, the two arrows appear - but they are not rotating. Then the screen became blank and start to flash every few seconds.
A few points:
- The reader is fully charged.
- I tried the "Hard reset" again - connected to the computer and not connected - it ignores the fact that i am holding the "Home" and "Menu" buttons, and continues into it's flashing mode.
- I tried to "rescue from SC card" according to the wiki page about rooting the PRS T1 - Again, no results: ignores the pressed buttons and continue on.
- the version of the firmware is 1.0.04.12210.
Anything else that I can provide - ask.
I have no idea what to do from now - I will greatly appreciate any help.
Thanks, Yoni.